Specifications
Drilling Diameter, Maximum |
2” |
Drilling Depth, Maximum |
72” |
Chuck |
16” 3-Jaw |
Hole Thru |
5” |
Swing Over Ways |
12” |
Spindle Speeds (Variable) |
300-2650 RPM |
Spindle Horsepower |
30HP |
High Pressure Coolant Pump |
25 HP |
Electrics |
3/60/480 V |
Approximate Drill Dimensions |
21” Length x 32” Width x 80” Height |
Approximate Coolant System Dimensions |
60” Length x 32” Width x 82” Height |
Equipped With
EQUIPPED WITH:
Tailstock with 5 HP Variable Speed Counter Rotation with 9-3/4” 3-Jaw Chuck and Controller for Tailstock Advance-Retract and Rotation.
Work Support Carriage with a 15-3/4” 3-Jaw Chuck with 5” Thru Hole and Pressure Head.
Operators Control Station with Spindle Pressure and Drill Monitor Load Meters.
Spindle RPM Display.
Spindle Variable Speed Controller.
Feed IPM Thumb Wheel Selector.
Manual and Automatic Operation Controls.
Manual Controls for Spindle Run. Pressure Head Return-Advance.
Tailstock Return-Advance.
Counter Rotation.
Manual Feed Advance-Retract.
Chip Conveyor Forward-Reverse.
Coolant.
Master Stop-Start.
Counter Rotation On-Off.
Emergency Retract.
25 HP High Pressure Coolant Filtration System with 5 HP Filter Pump that Removes Coolant from the bottom of the Settling Tank and Pumps it through Filters into the Clean Coolant Top Tank.
Free Standing Electrical Cabinet.
Coolant Kooler Chiller.
Chip Conveyor.