4” X 48” Phillips / Technidrill BTA Ejector Type Deep Hole Drilling Machine

Brand
PHILLIPS

Model
BTA

Stock #
HSD1170

Condition
Used

Year
1981

Location
Lake Bluff, Illinois
United States

Specifications

Drilling Diameter, Maximum 4”
Drilling Depth, Maximum 48”
Feed Rate .5 to 12 IPM
Swing Over Ways 20”
Swing Over Work Surface 32”
Spindle Speeds Variable (Parker DC VS Drive)
Spindle Horsepower 40 HP
High Pressure Coolant Pump 15 HP
Electrics 3/60/480V
Approx. Drill Dimensions 188” x 48” x 72” Height
Approx. Coolant System Dimensions 128” x 64” x 96” Height

Equipped With

EQUIPPED WITH:
Operators Control Station with Spindle Pressure / Drill Monitor Load Meter. Spindle RPM Display. Spindle Variable Speed Controller. Feed IPM Thumb Wheel Selector. Manual and Automatic Operation Controls. Manual Operation Controls for Spindle Run. Coolant. Rapid Advance. Forward Feed, Retract, E-Stop, and Emergency Retract. Updated with Parker DC Spindle Speed Drive.

High-Pressure Coolant Filtration System with 7.5 HP Filter Pump that Removes Coolant from the bottom of the Settling Tank and Pumps it Through Filters into the Clean Coolant Top Tank. Micron Polishing Filtration with (2) Cartridge Type Filters. 15 HP Grundfos High-Pressure Coolant Pump. Chip Conveyor. Air-Oil Mist Lubrication to the Spindle. Automatic Way Lubrication System. Transformer. 

32” x 72” T-Slotted Work Surface. Tailstock with Spring Loaded Cup Type Support. (3) Pressure Heads. Large Assortment of Spring Collets for Pressure Heads. (2) Drill Bush Heads with Large Assortment of Sleeves, Bushings, and Lock Nuts. Large Assortment of BTA Tubes (Some Extend for up to 96” Drilling). Large Assortment of BTA Drill Heads. 

Machine Videos